There are two options for laying linoleum on the floor. One of them involves the use of glue, the other is carried out without it. But with any of these options, it is necessary to initially align the floor. If the base is a cement screed, it is first necessary to put boards or chipboard on it.
After that, the linoleum in a spread state is withstanding on the floor for two days. Before starting to attach linoleum, it is necessary to cut it in such a way that it does not reach the walls of about 1 cm. Then there will be no problems in the future if the material will expand due to an increase in humidity in the room.
Then half of the linoleum roll is wrapped on the opposite side and is well coated with mastic or special glue. After that, you will have to wait about an hour before starting the gluing itself. Когда пройдет этот период времени, половину рулона необходимо вернуть обратно и при помощи щетки выдавить воздух. The second half stick in a similar way. You can start operating the floor after two days of glue drying out.
In a small room, you can not use glue to attach linoleum. But you need to make sure that the linoleum sheet does not move away from the floor surface. To do this, it is attached to double -sided tape.
The most difficult thing is if you have to cover the floor with two rolls. With this option, a seam remains into which water and pollution can fall. To make the seam well protected, it must be treated with cold welding. From the inside, the segments of linoleum are connected by painter tape.
Sometimes recently glued linoleum is suddenly covered with bubbles. This means that the material could not grab. To solve this problem, a heavy object is put on a complex site and is left for about 24 hours.
You can skip the recording and leave a comment. Link placement is prohibited.
